Replacement (Billet EN24T) Wishbone Bolts incorporating the rear splitter mounts. Laser cut and folded Air Dam (80mm high) with built in'L' Brackets. End brackets to fit once dam is cut.
Items are raw finish aluminium/steel/wood etc. But look great if you paint everything black! All of the pictures on this listing use this kit. Fitting Mechanical experience and tools required!!! Remove the left and right lower crash protectors.
Replace the front wishbone bolts with the ones supplied. Fasten the front splitter mount to the M8 holes where the lower crash structures were. Lift your splitter up, fix the rear with some M10x30mm Bolts and washers. Mark the front mount holes USE ALL HOLES!
Remove your splitter and drill the holes. Re attach and bolt the front mount to the splitter using the coach bolts. Trim Bumper if needed (depends on type). Mark the air dam location so it is as tight up as possible to the bumper.
Remove bumper or remove the splitter. Screw dam to the splitter (1/2 long screws). Trim the dam ends to match the splitter (sheet metal shears or grinder).
Fit the stainless steel end brackets. Re-fit the bumper (or splitter).The item "Honda Civic EP3 Type R Splitter FULL Kit UPACLICK" is in sale since Wednesday, February 5, 2020. This item is in the category "Vehicle Parts & Accessories\Car Tuning & Styling\Racing Equipment & Accessories". The seller is "upaclick" and is located in Sheffield. This item can be shipped to United Kingdom.